System Settings | Configuration

Configuration

  • Test Report Time (HH:MM): Used in conjunction with the Test Report Time is Periodic option (defined under Settings | Options (see System Settings | Options)) to set the time of the day or the period that the test report trouble input activates. When the Test Report Time is Periodic option is enabled the time programmed will be used as a period between reports in hours and minutes, otherwise it is treated as a time of day.
  • Automatic Offline Time: Allows the panel to update the users and other offline parameters on all intelligent modules at a set time of the day.

  • Module UDP Port: Some modules, such as the Protege Module Network Repeater, can communicate with the controller over an ethernet connection using the UDP protocol. This field defines the UDP port that will be used for these communications. The default port is 9450. If this port is changed at the controller it must also be updated at all relevant modules.

    After changing this port you must restart the controller for the setting to take effect.

    Module Comms UDP/TCP (9450) is disabled by default. It can be enabled by adding EnableModuleUDP = true or EnableModuleTCP = true to the Commands field in the controller programming as required.

  • Default Keypad Language: Defines the language selection for keypad displays. Select from English, Czech, Dutch, Estonian, Finnish, French, German, Greek, Italian, Norwegian, Polish, Romanian, Russian, Spanish, Swedish.

  • Touch Screen UDP Port: This is the UDP port that a Protege touch screen will communicate over.

    Touch Screen Comms UDP (9460) is disabled by default. It can be enabled by adding EnableTLCDCommsUDP = true to the Commands field in the controller programming.

Note: Ping is disabled by default for the onboard ethernet connection. It can be enabled by adding EnablePing = true to the Commands field in the controller programming.